快穿之辣h娱乐圈,塞东西走路play

Your location: Home- > Company News

You need to understand the acceptance inspection of Dongguan factory service


First, the specifications, first of all, the specifications, that is, as everyone knows, the size of the clothes must be positive, do not mark M, but actually L. Garbled or wrong codes appear.
Second, workmanship to see the line, the line, mainly to see if the clothes line is straight? Is it symmetrical? Is the stitch pitch thin or dense? Generally, the better the pitch is, the better it is at the beginning. Is there a "reverse stitch" and the stitching is not aligned? Reversing stitches: When a piece of clothing is started, it is generally necessary to walk back and forth for a few stitches, so that it is not easy for the clothes to open, and when a part of the car ends, the stitches must be reversed. It is more obvious to prevent him from violating the mouth when he pulls. Generally, for example, a woven skirt, you can see if he has a few stitches at the interface, and see the side seams. , Most people do not pay attention to the place to see, "collar" "sleeve, cuff underarm, etc."
Third, standardize packaging, look at a piece of clothing, first tile it down, and see if there is color difference, except when the time is right, and whether the clothes are evenly up and down, and then check whether there are small holes and so on.
4. Whether the lanes are tidy. The looseness and tightness of this pull line have different requirements in different parts. For example, the shoulders and the parts where the human body often moves, it is better to loosen it. It is better to be tighter at the bottom of the clothes. Best, neckline, neckline pins, underarm cable, whether the interface has a reverse pin.
Fifth, the plate shape is not symmetrical, and the slices are not neat.
6. The thread is clean and the clothes of the general brand. They have a tail and a special person to cut the thread. Generally, cheap clothes are not available. There is also a piece of clothing, if the quality is good, it is best not to exceed 1CM.
Seven, ironing, pay attention here, if it is hot drilling clothes, see if the drill is easy to fall, if it is high temperature pressure drill, it will not fall! Is the hot drill easy to fall.

shut down
点击这里给我发消息